Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Hello and q about handshake w Roland PNC950

Discussion in 'New Member Introductions' started by Grafxonlocation, Jul 1, 2016.

  1. Grafxonlocation

    Grafxonlocation New Member

    Jun 30, 2016
    Greetings fellow signmakers!
    Please help!
    I recently upgraded to relatively current technology in both software and my Apple Computer. However, my old Roland PNC 950 no longer communicates with it. I have used this cutter before with a serial to USB cable and a similar computer. The handshake is no longer working. I have bought a new cable, and this is not helping. Are the assignable pins on the side of the cutter (currently set to "off")a possible solution?
    Any help in this matter pointing me in the right direction, would be of invaluable service!
    Fraternally yours,
  2. The Big Squeegee

    The Big Squeegee Major Contributor

    Welcome from OK

    :Welcome: 2 :signs101:
  3. SignBurst PCs

    SignBurst PCs Very Active Member


Share This Page