JFX200-2513 Problem

[TomZ]

Problem with my head position moving untill it starts hitting the sides. But prints right where it should.

 

[Solventinkjet]

Not sure what that means. Can you be more specific?

 

[TomZ]

As the head moves back and fourth printing it starts to travel in one direction more then the other till it starts hitting the stops

 

[Solventinkjet]

So the head moves further and further to the side, prints in the correct spot but eventually hits the side of the printer? If that's the case, you might need to have someone come out there and check it out. That's a very rare issue and could be caused by a lot of things. I would update the firmware first and then troubleshoot from there.

 

[TomZ]

Thanks but it was the y motor encoder. I changed the motor and the problem went away. The encoder strip is for print placement and the motor encoder is for head movement.