• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Mimaki CJV30-130 Cutting Problem

A

adambrooks

New Member
Hi Guys,

I have a problem with finecut.... whenever I go to plot a design over a certain size it renders up to about 45% and then stops rendering, but it still tries to cut but only cuts half the design.

Any ideas?

I'm using Finecut 8 with Corel x6
 
Solventinkjet

Solventinkjet

DIY Printer Fixing Guide
I'm not too experienced with using FineCut in Corel. I was talking with one of the techs at Mimaki yesterday and he said that when you upgrade to FineCut you may need to upgrade your Firmware on the machine as well. He said there were a couple glitches that they worked out with the new firmware in regards to FineCut 8. Did you just recently upgrade?
 
You must log in or register to reply here.
Top