Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Roland sc-500 cutting printed work not in register

Discussion in 'General Signmaking Topics' started by hankweezie, Aug 17, 2012.

  1. hankweezie

    hankweezie New Member

    Feb 19, 2012
    Parsippany, NJ
    I have a roland sc-500 when my machine starts to cut my printed graphic it slowly goes out of register, cutting sometimes an eighth of an inch off. It starts out fine then on a 5 ft graphic it is off at the tail end.
    Anyone have an idea what causes this?
    Does something need to be calibrated?
    Would appreciate some help

Share This Page