Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

stops cutting

Discussion in 'Roland' started by sb317, Jun 1, 2012.

  1. sb317

    sb317 New Member

    6
    0
    0
    Feb 17, 2011
    I have been searching and found a few hints but figured I'd go ahead and ask. We have a Roland SP540i (bought new last year). Right now we are printing and cutting some decals out and for some reason when we go to cut, it stops cutting halfway through the run and will display "now processing". We are using the same material we always use. We haven't had an issue up until this point. Could this be a file issue? We aren't doing anything different on these from what we do anything else. Thanks for any help.
     
    Tags:
  2. sb317

    sb317 New Member

    6
    0
    0
    Feb 17, 2011
    Got it figured out. It was a file problem.
     
  3. guato

    guato Member

    90
    0
    6
    Jul 16, 2010
    Slovenia Europe
    Try to clean cutting strip.
     
Loading...

Share This Page

 


Loading...