I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
About hand braking:
I start typing on the table.
The gantry comes to the desired position.
The carriage starts to drive to the starting position and at this point I start to hold her down a bit with my hand. Giving it a little resistance/braking.
And as a result of this, the error does not...
About hand braking:
I start typing on the table.
The gantry comes to the desired position.
The carriage starts to drive to the starting position and at this point I start to hold her down a bit with my hand. Giving it a little resistance/braking.
And as a result of this, the error does not...
Ok, I'll try to make a register and check the indicator all the way through the encoder.
But still, why does the roll work then? And why does hand braking work?!
I'll try the registry files.
Yesterday I tried braking the carriage with my hand, as if to help brake, at each carriage edge position.
And the printer worked without error!
Most likely the problem is in the motor or in the gantry board....
I also changed capacitors on all three boards just in...
The magnet is present. The test in SDS passes successfully.
Yes and the printer prints correctly on the roll!
Thanks to these magnets it passes the initialization always successfully.
As far as I know, magnets are only needed in the beginning to determine the starting point. Afterwards the...
I have an old HDD with a known working OS. I plugged it in and the problem still persists.
There is a very unusual fact...
It turns out that the printer can work on a roll !
But when returning to the parking lot it also hits the limiter ....
I observe that the speeds and accelerations of the...
Hi! Thank you for your reply.
The printer is initializing correctly. In the SDS menu I ran a cyclic carriage test (50 cycles) everything is fine.
I did the test with the carriage encoders too, the numbers change.
I also pulled out the FireWire cable and unwrapped it, didn't help either...
Hey, everybody!
I have a problem with OCE Arizona 550XT printer.
When printing, the carriage moves to the start position and does not have time to stop.
This causes it to hit the stopper. This is shown in the video.
On flatbet this problem is always present.
On roll the problem looks a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.