Search results

Hello, i have 2 FC8600s. When cutting perf one of the two makes a strange noise like the blade holder hits the bottom metal with force. Everything else works perfectly with extreme accuracy. Only when cutting perf this happens. Both cutters have the exact same settings on perf cutting. I...

I reset the cutter, tried other PC, tried Corel and Illustrator, same thing happens. It happened suddenly after transporting it to other shop. I dont think has to do with transporting it. Was working perfectly fine.

Checked these. They are all correct

I get error because the second registration mark is out of the material, supposed its out of 55cm

I just checked. Its like the photo

Thanks for replying. I will check and get back. The correct selection for detecting correct roll width and not fixed size is exactly like the photo?

Hello, after installing Finecut 9 v.3.0 to a new PC with Core 21, all of a sudden my CG-130 SR3 started having strange behaviour. Although it recognises the material length correctly on the screen, finecut is able to see everything as 55cm/ 22" length maximum. For example if i load a 54" roll...

Check your PM

I want to ask a technical question about my FC8600. If any technicians are in this forum please send me a PM

Finally figured it out! The page length was set to 2m, so everything over this was aborting. It could cut 4m for example color vinyl, but it couldn't read marks over 2m. Strange but this is how it works. I dont understand the use of page length by the way

Hello, i created a 15ft long printed file with segment marks every 42". I chose to cut segment by segment in last tab of CM4 but i always get error 4017. It reads the first 4 marks ( first and second), cut fine, then search for the third segment marks and i get error 4017. Am i doing something...

Old comment, but I think designing all pieces is the most difficult part, not printing them

Yes they are on the same PC. The Mimaki is on remote option. 2021 is ok 2022 only available the serial connection (never used serial)

Hello, i just installed the latest FineCut 9 2.4 today. In CorelDraw 2021 works correctly. In CorelDraw 2022 it cannot connect. Im connection tab only serial is enabled. USB and network are gray disabled. Anyone tried this Combination FC 2.4 and CorelDraw 2022?

How about the edges? Won't leave white gap?

Maintenance cartridge, and generally all moving parts like Belt, felts, motors, etc. Just faster wear. Also SMK come faster. More electric consumption. Why don't you just replace the printhead?

Light areas are always less glossy than darker areas because of the more ink printed in dark colors. Its always like that. For black areas specifically you can change GCR evels, so it will add more black and less other colors to achieve the same black but with less ink. Also create a profile...

Thanks for the reply. I will give it a try, but as the pc is connected to internet with Ethernet, it won't go to sleep mode the network card

It's in remote node. Yes this is super annoying on Mimakis!! I will check the power management in settings. The ip is reserved from the router. In the network shows connected, just the corel cannot communicate. Its like not exist.

I have a CG-130 SR3 connected with Ethernet to my router with static ip. Sometimes trying to cut from Corel the cutter is not reachable. If i connect the USB works fine. Anybody had same issues with this cutter connected with Ethernet?