Recent content by 123sticker

Different, but maybe better to PM me for that?...

I think all these chinese printers work the same. The connection between the control software and the printer is over USB.... Yes, i know... not ideal.... It means that for every printer you need a computer to print. With Roland; we have 3 printers connected to 1 rip. That is impossible with...

The difference in my first connections and those of Jimmys show, that a 3 phase without neutral is possible. It also says so in the site preparation manual. An engineer can find the 2 power boxes (in my machine the 2 silver ones) and look what they need for input. Then follow the connections to...

As far as I know, the summa uses the 3 phases only for the Vacuum pump BUT the rest of the electronics run on 220 Volts (or maybe on 110 volts when differently converted). That usually is taken from 1 phase and NULL. Do you have that connected? When the summa doesn't start up at all, it sounds...

Hi there. I also have several 'chinese' 320 cm printers. I know this issue!!! With me, the problem was 'lack of computer power'. So, the computer has to calculate a lot of data to do '1 pass'. That's why it prints, and then waits. Go to your task manager and look for CPU / MEMORY usage. I'm...

Hi there, My Gerber slipped when moving it to another table and fell right on its front. Now I need a display panel. The machine is pretty old but we still have some jobs for it, so a working used one would fit the budget. Since Gerber doesn't have them on stock I hope that someone has one...

Hi there, do you have spare parts for Gerber Edge FX? I need the contol panel with the display and buttons. Please let me know if you have it.

Hi, Does anyone know if the Opos X functionality can be changed? Normally, it needs 4 points on which it makes its adjustments. I want to reduce that so that it only reads the first point. Our material has many repeating (small) jobs and is fed into the machine absolutly parallel. THerefore we...

Yes, it is replaceable. I was hoping for a non responsive sub power not working. Then there is something else wrong with that machine. Have to keep searching

Does anyone know what the backup battery is for, and what happens if it doesn't work anymore?

The problem started when the wipermotor could not deliver enough power to clean the heads. We then changed the chip on the servo board. Now when the printers main power is on, the 'sub power' cannot be turned on. Pressing the power button doesn't do anything. Because of the repairment, the...