I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
wow your saying you cant print them for $350....I must be missing something either the material cost i figured or the amount of sq.ft needed must be way off in my projections. ( i am not doubting you, as you are in the large format field )
Feels like i am pissing into the wind here....lol...
The Side x Side market is mainly what i am shooting for. They spend tons of cash upgrading their machines. Its not uncommon for them to have more in upgrades then it cost new. Figure a grand or so on a custom wrap is a drop in the bucket to most of them.
hey thanks for replying to my thread. I have 2 big polaris dealers in my area & I want to approach them about offering wraps for their atvs & utvs. Also close to a major university so i may apply for licensing so i can use their trademarks on some wraps. I have researched about what it would...
looking for a wholesale large format printer who prints and laminates using convex to be used on atvs & side by sides.
Was thinking about buying my own setup, but after reading posts here not sure i want to inhale all the chems. I need to keep the few brain cells i have not killed yet...lol
I just received my new graphtec 24" cutter & I have a problem, when i poll the cutter it sends back my width & length reversed ( it will say my width is 196" & my length is 13" (for a 15" roll)...when my width should be 13 & length 196...
Also in cutting master the panel shows where the design...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.