Recent content by Fly N Dutchman

I received some new fuses. Replaced 2 of the card cables that had bent pins on them. It is still blowing the F1 fuse. Any one know what to look for next. it is still blowing the F1 fuse. I removed the carriage board and do not see any problems with it. I looked at the service manual and it seems...

I received some new fuses. Replaced 2 of the card cables that had bent pins on them. It is still blowing the F2 fuse. Any one know what to look for next. it is still blowing the F2 fuse. I removed the carriage board and do not see any problems with it. I looked at the service manual and it seems...

Could I ask who you sent your board to? I have kind of had the same thing bent the pins on the cable and blew the fuse. replaced cables and keeps blowing fuse. Thanks

I did creat in Flexi. I then made 9 copies wide in Versa works. the one on the right came out good but the cut gradually went off when i did the print and cut. I will try to make 9 side by side in flexi and then send that to versa works and see what happens.

When doing a print and cut on some 54" mat the right side is right on but the left side is off about 1/8 " or more. Did the print-cut adj with the 3 small black boxes 1 on right 1 center and 1 on the left those print and cut come out right on the money. checked the auto env.match and that is...

I have been trying to unclog my cyan print head but it seems to be going from bad to worse. Where is the best place to get the best price on a print head? Going through my regular supplier they want like $1250.00 for a new head. We are a small shop and would like to get a better price. Are there...

I would like to get a manual and some contact info if I could.

I would like to get a manual and some contact info if I could.

Could I get a copy of that manual I have the VP540 as well. I just got a quote for 375.00 travel and 185.00 per hour. I thought that was pretty steep. I have a good mechanical background and good computer knowledge. I am getting the over spray also. Replaced the capping stations but don't think...

Well the tech came out and spent about 4 hrs on the machine. He was confused also and was on the phone with roland support and finally got it fixed. He finally went into the print and cut menu and zeroed out every thing. Then went into the service menu and started to calibrate it from in side...

Talked to the tecs today and they are suposed to send someone out tomorrow. On 48" media I worked with the test print and cut and got the center dead on. Now the one on each side is off in oposite directions about 2 cm. The tech said that was too far off and they would need to clean a strip...

My cuts have been a little off when doing a print and cut. So I did the print and cut test and did the adjustment for the feed and scan. When I do a test print it does do the 3 little squares. The first square to the right comes out perfect. the middle 1 is a little off and the left one is about...