I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I have a 64" HP latex cutter that has recently started cutting all lines about 1/8" too far to the left.
I have run all the calibration I can think of and rest the ops. Do you have any suggestions to get the cut line back on track?
Ok, still no luck with this. I have been through the setting and can't find a way to set custom parameters on the optics. (auto media setup isn't working) It's a large run but I'm willing to set the alignment manually but can't figure that out either. Any advice?
I am trying to print and cut on orange vinyl. My HP Latex printed does a great job of printing on the vinyl but my HP cutter cannot find the digitized marks. (I suspected it wouldn't) Any clue if it is possible to trick the cutter into finding the marks?
I recently got an HP Latex print and cut package. today I printed decals on reflective material. When I took the print over the cutter it was not able to locate the barcode. Anyone know a trick to getting the cutter to read the barcode on the reflective material?
When moving a Roland Vp-540 do you really need to drain the ink from the printer? The printer may be tilted slightly to fit in an elevator then take a ride in the back of a box truck.
I have some old cleaning cartridges that are at least half full am I able to reuse those to flush the ink, or...
I am looking for a recommendation for a printable material I can use to make flags? I will be printing these on a Hp latex 335 so the material will need a liner.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.