I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
So after exhausting all posibilities,
I decided it was probably like all the other graphtecs I read about.
something wrong on the mainboard.
Staring in the face of most likely paying 450.00 + labor or more for a replacement main board,
I decided I would dig deeper into testing the main...
I've had the plotter for over 2 years. Used very lightly, meaning I tried to start a side business doing vinyl graphics and it didn't take off.
Anyway, I'd say it has probably been used/ran 70 times.
I dont get error codes except for only the x position alarm.
I'm basically putting a 12x12 inch...
Yes,I have,
I have also upgraded the firmware.
Opened the side caps to see if the motor was obstructed/dirty.
Checked for bad capaicitors/checked for loose connections on the pcbs/main boards, etc.
Today I went back and looked at the sensors.
There is a 'docking' as i would call it sensor...
Hi all , Just joined and am new here.
I've got a graphtec cutter i've been on and off trying to fix for about a year.
Scouring the web for a solution. no dice, but some interesting leads.
I'm a hobbyist, so i've never really put the thing through the demands of daily use.
Just to start off I'm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.