I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Using Signlab. Cutter sees all 4 Reg. Marks and goes back to start and travels to second one and keeps going after I send cut command. Cant figure this one out.
Thats what I have to do to get Black to work. Color still has hissing sound when pulling. Squeezed hose at capping station and it stops air release...therefore I don't think the head is sealing with capping station well.
The Black ink can be drawn thru waste line but color seems to be sucking air. Just changed heads and capping station. Do I need to prime or is their an adjustment to make it sit tight against seal? Have ink to heads but can't pull thru.
Thanks
Just changed heads and capping station. Can't get ink to capping station. Black ink pulls thru OK and prints perfect in test. Is their a way to prime it to start flow. Have ink to dampers. No blocks to waste tank air pushes back thru.
Finally got Black to pull thru. Color must have leak. Will replace "O" rings next week. Still doesn't print black in nozzle check. I think I checked right fuses. All OK.
Wants to do a print test...But nothing comes out. Getting "O" rings next week. Entered NEW Head Rank Numbers. Still nothing. Getting the two beeps when it starts to print. Can't pull any ink out of heads when in capping station thru waste tubes. Thanks for looking.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.