I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Yep that's exactly the thing I need, BUT there is no option in the menu's for my plotter where I can turn it off. Having read up on it now I think i'll leave it alone. It cuts perfectly at the moment and I don't need anything going wrong. It's just annoying when I leave it while it's running and...
Hey All, I have a HP335 print & cut setup and when I cut just plain coloured decals (not printed) on the cutter it will stop at a random interval and feed a heap of media through, then run all that media back and continue cutting from where it stopped. I have checked that I don't have any panel...
It was pretty old I think but I didn't expect that a firmware update would change too much about the actual running of the machine. The problem I now have is when the substrate is initially loaded into the printer and I select what type of vinyl it is, usually the vacuum fans start up and suck...
Hey guys. Anyone seen or have a fix for the vacuum fans not working when loading media? After assuming my printer was doing auto firmware updates, yesterday I realised that was not the case! I downloaded and installed the latest firmware and now when I attempt to load a new roll of media the...
Thanks for your help guys. I went through the plotter settings and there is a 'panel' option in there. It was set to OFF but there was a 50cm option in the panel tab that was checked. I have changed that to 0mm in the hope that will fix it. If that doesn't work i'll change it to 250cm which is...
Thanks for the reply. I am using Flexisign and can't see any option for prefeed and from what I can see I don't have any paneling options checked. It tends to happen mostly when cutting something approximately 1 meter or longer so I guess it could be a paneling issue? Might have a dig through...
Hi guys, new member from Australia here. I have a HP335 latex print & cut combo. When cutting plain coloured vinyl on the plotter (which I believe is a rebranded Summa) it will stop cutting at a random time and advance a certain amount through and then run it back to where it stopped and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.