I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Justin, please check the Festo Valves on the backside from Headboard......change one valve from other one and see if the issue changed too........if this the issue......so you can check up to clean up or renew.
Justin, please check the Festo Valves on the backside from Headboard......change one valve from other one and see if the issue changed too........if this the issue......so you can check up to clean up or renew.
1st change the Pressure/Vacuum Valve "Festo mini 2-way valve" change means.....use the LM Valve to LC place and LC Valve to LM Place and see if the issue now on LM.....
Festo Valve not close correctly think thats all.
Check and come back with result.
on mainboard you find a block auf transistors "with cooling frame" they have short circuit....iam be sure......if you like to repair them can give a contact in Milton Keynes or send it to our hand.
Parts ~ 50,-€
to little information to solve it.....but on nozzletest seen very crap all......
1st. check the voltage from PH
2nd. show its PH-heater working
3rd. perform clean jets procedure
4th you can adjust the Heatvoltage little bit higher..........write on it 20Volt......put 21.50Volt.....aso.
come...
start ink load procedure.......and disconnect the inkpump motor connector (grey plugs) and wait that system ready with the inkload procedure ! or what you like to do now ?
if there any problems with inks....then all heads with same color will be in trouble.......thats not from ink.
picture is very small and cant see it correct.....but seen be that full blocks of jets missing.....
to check: if under the Heads is ink drops....seen be thats a airleak...check the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.