I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Using Signlab. Cutter sees all 4 Reg. Marks and goes back to start and travels to second one and keeps going after I send cut command. Cant figure this one out.
The Black ink can be drawn thru waste line but color seems to be sucking air. Just changed heads and capping station. Do I need to prime or is their an adjustment to make it sit tight against seal? Have ink to heads but can't pull thru.
Thanks
Just changed heads and capping station. Can't get ink to capping station. Black ink pulls thru OK and prints perfect in test. Is their a way to prime it to start flow. Have ink to dampers. No blocks to waste tank air pushes back thru.
Just replaced print heads and dampers. Pulled ink thru dampers and still no ink comes out on test print. Mutoh Falcon Junior 38. Please advise. Thanks in advance.
My cutter seems to step-cut around my "O" & "C" and any round cut rather than a smooth rounded cut. I installed NEW Blade Holder and Blade. Running Signlab. I can't seem to find out what is causing this problem. Thanks for your help.
I don't know what happened. Now my very small letters are not cutting very sharp. The "O" seems to cut in steps instead of flowing around the curve. What should my settings be? I forget what they were.
When moving my knife into position a couple of inches up on the vinyl it moves so SLOW. My SignJet would move faster if the button was left down. Can I do anything to make it move faster?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.