I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I run a Mimaki UCJV300-160 using the Ricoh Gen 5 head and your diagnosis was spot on. After doing a #Adjust: #Head Voltage test print and adjustment, my cyan overspray issue was resolved. I had a full wall wrap printed except for 1 panel when the color shifted. Been trying for a week to fix...
I ordered a Ricoh Gen5 Printhead for my Mimaki JFX200 on March 21st and it was listed as "on stock" on their website so I selected 2nd Day Air thinking I would get it in a few days. Our cyan was not looking good and we couldn't get it to recover so we were ready to drop the $$ on a new head...
I have been operating the 5460 (35500) for 5 years now. I agree with the others. It requires monthly inspections on the chain because there is so much movement of the cables. we have had several ink lines and Lamp cables get holes worn in them. We have two of these machines and I typically...
Finally got my printhead back from the Printhead Doctor in January. I tried their "new and improved" solution but did not receive any results. The printhead I had sent back to them was junk when I got it back. Only fired half of the jets. Vladimir told me I could return the machine with a...
Customer Service terrible at Printhead Doctor
I tried it. Not pleased at all.... I got the machine to refresh some of the printheads on one of my HP35500 (Colorspan 5460). Upon receipt of the machine on October 6th 2011, I ran it multiple cycles at the specified pressure. The jets...
Vacuum Recovery
Also, for the vacuum recovery issue, I have had this happen to me and tech support gave me a lot of things to check. I checked all the lines for kinks, holes, bad connections etc. but to no avail.
I found the problem within the vacuum pump. There is a small brass connector...
Carriage Movement OK?
Quick question. How smooth does your carriage run? I have 2 HP35500 UV printers and was having problems with declining print quality. I would get strange variations in solid colors, etc. I noticed the carriage was running a little rough and checked the bearings. The...
Use a sled?
I have been printing on 1/2" Omega board and Alumalite with minimal problems. The problem with some of the thicker materials is that they have a slippery surface. We place our material on a coroplast or foamboard sled so the grit rollers have something to grab. It feeds pretty...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.