• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. Mini power outages on XR-640?

    Just wondering if anyone else has encountered this issue. It started last week and happens randomly so far, no rhyme or reason that we have figured out. Our XR-640 is printing along fine and then just stops - it isn't a data hiccup issue because the screen would read now processing - I...

  3. Main Board Replacement Help CE6000-60

    Has anyone replaced the Main Board in their CE6000-60? Of course ours is just a few months out of warranty and because I didn't buy the board from one of their approved reps, Graphtec is being less than helpful. I am looking for either the pages from the service manual related to switching out...

  4. Cutting Master 2 and multiple plotters?

    Hi All! Is anyone out there running more than one plotter with their Cutting Master 2 software? We have our old CE-3000-60 workhorse that still works great (most of the time) and recently purchased a CE-5000-60 to work along side the other one until it gives up the ghost. Cutting Master...
  5.

    Engraving Font ID

    Hi Guys, My engraver said she spent an hour trying to ID this font. Can any one out there tell me what it is so I can tell her? It looks pretty standard to me but it has been many years since I've done any engraving. Any help would be appreciated. I went through all my standard system...

  6. Help, XC-540 Major Dot Drop-Out

    Hi All, I am hoping we don't need new print heads but we are experiencing some major dot dropping on our test prints. Cyan and yellow are affected the most. Have done normal, medium, powerful and manual cleanings and it is not helping. We replaced the cyan cartridge on Friday, has anyone...

  7. CE3000-60 leaving nubs

    I Copied this from a thread from about 2 years ago. Initial Blade down leaves nick - WHY? I'm getting these ugly looking "nubs" and it looks like they are being left in spots when the blade goes down initially. Anyone know what could be causing that? Even cutting super slow it does it...

  8. Well, it worked before...

    Hi Everyone, I am new to Signs101, but from what I have seen, I am pretty sure that one or more of you great sign maker/ computer guru's can help me. :notworthy: We recently had to rebuild one of our computers, so when we re installed all the software, everything works good except I cannot...
Top