-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
I need a mimaki jv3 tech ******
- Thread starter tooserious
- Start date
tooserious
New Member
Yes but it got a little better..
I think I will calibrate it when i go ahead and put the encoder sensor on it tomorrow...the old one had been rubbing on the encoder.
I just did a full 4 x 8 banner and the colors pop. It is still on the machine ....I tried printing a while ago and it was terrible then I cleaned the new encoder with alcohol
and it seemed to have helped I also put the machine back to the reset (I thought I messed up) But when I rebooted the printer it did fine
I think I will calibrate it when i go ahead and put the encoder sensor on it tomorrow...the old one had been rubbing on the encoder.
I just did a full 4 x 8 banner and the colors pop. It is still on the machine ....I tried printing a while ago and it was terrible then I cleaned the new encoder with alcohol
and it seemed to have helped I also put the machine back to the reset (I thought I messed up) But when I rebooted the printer it did fine
Attachments
tooserious
New Member
So so far
If the encoder goes bad it messes up other things too!!!!!!!
If the encoder goes bad it messes up other things too!!!!!!!