robert griffith
BIG BOB'S SIGNS & GRAPHIC'S
Roland SP300V Error Code Comes on when I true on the Printer CODE 0120 Just put in New Heads and Dampers Head Caps Head Cables all the good Things.
-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Need Help Roland SP300v Error Code HELP
- Thread starter robert griffith
- Start date
JBurton
Signtologist
Looks like an issue with the thermistor, here's info on it and a link to the document I pulled from.
printcopy.info
- Code: 0120
- Description:Thermistor Error (Print Heater)
Thermistor of the Print Heater doesn't work correctly. - Causes:Thermistor of the Print Heater is broken.
- There is a cut-line/short in the wiring of the Thermistor.
- Remedy:
- 1) Check the wirings of Print Heater
- 2) Thermistor Replacement
Error Codes > Roland > SP300 VersaCamm > page 2
printcopy.info
If you had just changed the heads I would look at replacing the cable to the black head, or swapping it with one of the others. The printer gets the head temp from the black one. I cant see any reason changing the heads would have damaged the platen thermistor. I was getting a temperature too low error once after a head change, and it was down to a bad black head cable.
Also try turning on in service mode, there is a thermistor check feature on the menu that will show if it is getting a signal
Also try turning on in service mode, there is a thermistor check feature on the menu that will show if it is getting a signal