I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Hi ALL
Just wanted to follow-up with you all.
I'm back-up in production - thanks to all your help.
Couldn't have completed this project without the help of this forum and "YouTube" :)
Yes I used an aftermarket printhead (as the Roland printhead was twice the cost)! Aftermarket parts are like buying NAPA parts - nothing wrong with them (in my opinion) and best of all they cost less.
Yippee!!! I just found the culprit - I did blow the Black and Cyan printhead fuse. I swapped...
Player, that's what I should have done too.
But all I did was to pull both sets of cables (which I swapped)
to check if the cables were good. In the morning I'll try what you said.
Thanks again for all the suggestions/advice.
Thanks for the leads....
I just did little test with the cables running to the Blk/cyan and M/Y print heads (swapped them around) hoping I would get the blk/cyan to fire up! But same results, only the magenta and yellow test printed again.... I'm hoping now that the culprit might be the fuse...
Hello All,
I just replaced my black/cyan print head, and now when I do a test print I am getting two sets of Magenta and Yellow printing! Image attached. I have done numerous power cleans, and have even syringed ink through the lines (to no avail). Any suggestions - would be welcome. Image attached.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.