I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Hi Mate,
I just bought the same printer and have the same issue...the cutting blade is doing nothing but prints great. I have a tech guy who use to service the machine from where I bought it from and is willing to help. I will give him a call some time this week and if any solution come up I...
I can't find any spring attachment in that area. I came across this post...https://www.signs101.com/threads/roland-not-cutting-blade-not-lowering.123326/. Could this be the case as I tried to cut and the cutter was not low enough to cut the contours. Thanks for your advise regarding the wipers.
Hi, I know this is an old post but I have a similar issue. Where you able to put back the string and where was the spring located? attached is the spring that came of mine
Hello,
I came across attached spring on a media/paper. The printer was performing a media/paper
detection width and the aluminium part of clamps obstructed the printhead. I have no idea where it came
from and where it should be. The printer still prints but I'm concerned it may affect the...
Hi Jim,
I managed to complete the "initialize the limit" procedure and did a print test and had the same results. BLANK WHITE. I moved the head to the left and saw that the caps have no inks at all, BLANK WHITE just as previous pics. Please do you any suggestion? I'm thinking the head could be...
Hi Jim,
I tried your advice and came at a standstill after I moved the head to the locked cap position. I pressed enter and then the machine came up with a message "unrecoverable limit sensor"...please see attached image. Non of the buttons on the machine would work except for the on/off button...
Thanks for your update...I tried what you suggested however, it appears that the suction is not airtight. When I pull the syringe, it feels like there is air coming through from some where....and I keep pulling and there is nothing but air. Please advice. Tnx
Hi Mate,
I finally replaced the cap tops with brand new ones and also the dampers and performed x3 powerful cleaning and did a print test and no ink was printed on the paper, "BLANK WHITE". I opened the capping area of the machine and found that the new replaced caps does not even have a single...
Hi,
I finally replaced the cap tops with brand new ones and also the dampers and performed x3 powerful cleaning and did a print test and no ink was printed on the paper, "BLANK WHITE". I opened the capping area of the machine and found that the new replaced caps does not even have a single drop...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.