• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by aubob1957

  1. Roland feed adjustment

    Any "old timers" with knowledge of this software(Cibercut 5.5 and Roland CM24) that can help with my dilemma....need ya. Bob

  2. Roland feed adjustment

    Yup, I used to be able to set it to loose a couple of inches, have to have it when you have a short piece left and need to use it all. Just can't figure how to set the adjustment...probably something real simple. lol

  3. Roland feed adjustment

    New to the Forum...greetings all. I had a hard drive crash and burn and I am now getting everything up and running again. Have re-installed Cibercut 5.5 (working fine) and software, drivers for the Roland cm-24. The Roland is cutting fine but it purges about two feet of material before it starts...
See more
Top