• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Bob Elliott

  1. Laminator beeps but doesn't turn

    If the E-Stop is pressed it won't run at all.

  2. Seal laminator spare parts

    Unfortunately, Don has to buy a lot of those parts from GBC and they gouge the crap out of you.
  3.

    Lamination problems

    What brand and model is your laminator? If the middle has bubbles and wrinkles and the sides look great that's an indication the rollers are bowing in the center. This is usually caused by adding too much top roller pressure if they are flat rollers. If the rollers are crowned, they could be...

  4. Laminator beeps but doesn't turn

    What is the model number. On some of those machines, the potentiometer is part of the Control Panel PCB.

  5. Seal laminator spare parts

    Go to gbcconnect.com.

  6. Need advice on GFP 563TH

    Make sure your laminator is attached to the stand properly. The front of the cabinets need to be flush with the stand where they contact each other. If one side is slightly back and the other side is hanging over, the bottom supply shaft will be out of tram with the rollers. If you have any...
See more
Top