• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by cayannie

  1. 300 vs 540 service info

    Awesome. Thanks for the quick reply & very helpful info.:wink:

  2. 300 vs 540 service info

    Hey all- Anyone know if there are any significant differences in the Service Manual between the SP300 machine & the SP540? Got the bigger machine now, & already have the Service Manual for the 300. Trying to decide if I should get the 540 manual also or if I can make due with the 300's...

  3. SP300 not reading material width

    Nothing, but if we are already waiting on part replacements from Roland, I wanted to make sure it also was not a possible issue so I can wait for all parts at the same time. ;) Turns out it was the carriage control board. Replaced & back to work again. Thanks to everyone who replied! Always...

  4. SP300 not reading material width

    Thanks, we'll try that to see if we can get her up & running til the new board gets here. Much appreciated!

  5. SP300 not reading material width

    That has already been replaced before this. It generates a pinch roll error when bad, which is not the same as what I am seeing. Remember, I have the service manual & have already checked it for info. :) This is not the cable. It is either one of the sensor boards or something else. I was hoping...

  6. SP300 not reading material width

    Our Roland SP-300 has decided it cannot read the material width (it shows up as 0.0), but it does not provide any error codes. We have the service manual, as well as a call into our Rep., but no info so far. Can anyone tell me if there is _supposed_ to be a red light on on the linear control...

  7. SP300 tool ribbon cable

    Does anyone have the actual usable part number for the tool ribbon cable for the VersaCAMM SP-300? Ours finally kinked, but my dealer is having trouble getting the part number to get it in for me?! Any help would be greatly appreciated.
See more
Top