I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Conect the printer direc to the PC. Put the same class IP ex. PC 192.168.1.13 and the printer 192.168.1.14, set for bouth device (pc and printer) the sub net mask 255.255.255.0 afther that in your internet browser type the printer IP and pres enter. If the printer and cable are ok the updat...
Make a best quality print...if is possible 12 pass and another print in low quality mode . Increase to the maximum the temperature for print and drier The issue is in the same position for both printheads.. . In my opinion the printheads are fine .
Clean the metalic outline of the printhead...must be clear metalic...I see dirth on it. And after that in service mode make the default head alignment...in service mod not user mode.b
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.