• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by cubanitaloka

  1. Gerber 408 Y-Encoder/Motor Error on Start Up

    Finally figured it out. There's two small cables (red and black) that connect to the main motor cable connection on the old Y-motor. The black cable had a small tear and was not making proper connection. As a result the motor was not getting power. I repaired the cable, tested the motor and...

  2. Gerber 408 Y-Encoder/Motor Error on Start Up

    Which encoder are you referring to? The cable that connects to the electrical box or the ribbon cable on top of the main circuit board?

  3. Gerber 408 Y-Encoder/Motor Error on Start Up

    Attempt 4: - Swapped x encoder/motor cable connections with Y - Y encoder/Motor error - Swapped the front/limit and left/right cable connectors as well - Y encoder/Motor error - Returned all cables to their correct connections, inverted the ribbon connectors for the X and Y on the top side of...

  4. Gerber 408 Y-Encoder/Motor Error on Start Up

    Hey all. I'm at the point of ripping my hair out figuring out what's wrong with this Gerber Sabre 408 CNC. Below is everything I've done so far. Issue: On startup, the error "Y Encoder/Motor" appears on the panel. Attempt #1: - Cleaned and oiled gantry rails - Checked lead screw - it moves...
See more
Top