I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
We would use white poly. (thickness is your call) We would print one layer on clear vinyl and one layer on white trans vinyl. We laminate the white trans layer. Apply the clear layer on the poly first,(may need transfer tape) then register and apply the laminated white trans layer on top...
Cory,
This is how I handle HDU Letters.
I use 1"dia pads from Gemini with 2" studs
I drilled a 1" diameter hole that was 1/2" deep at each stud location on the back of the letter.
First, I dry fit each pad and stud in its location to open the hole slightly.
Then I fill each hole halfway...
I had this problem a few years back. Make sure the ink cartridges in the back are pushed all the way in.
This can cause air to get into the lines. Hope this helps.
Here is what I built yeterday with 1" & 3/4" Aluminum square tube & 3/8" all thread
I did not want to drill into my bucket so I installed this onto the outside of the bucket & used the all thread to squeeze it tight to the bucket.
Should hold light signs & plex faces with no problem.
The...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.