Recent content by ignorance2

I need somebody with a L26500 not the L25500 to do and "all test plots" for me and post a picture of it. Go to the ink icon, then image quality maint. and hit print all test plots. PLEASE!!! I'm trying processes of elimination on a bleeding issue on two of my machines. Both of them are doing the...

+1 for Caldera with Barbieri! Color is amazing and very consistent. Ive used VW, Onyx, Wasatch.

When we went for the traning for our Zund they demoed a program that made box files for you. You would enter the dimensions and press enter and it would produce either an AI or EPS for you withh all the layers seperated (throughCut, Crease). I design all our boxes in Illustrator and use trial...

Caldera is hands down #1 in my book. Ive used Onyx, Wasatch, Versaworks and some Flexi. Caldera has given me no problems. On a side note if yopu do get Caldera I highly recomend getting the Barbieri easy color for making profiles! Its a large cost but in my opinion its worth its wieght in gold!

I have to completely agree with Bly. I used to use only preset profiles within the RIP. Never again will I do that!!!!!! We switched from Onyx to Caldera and I wish we would have done it years ago! I have never had such a great color consistency out of my machines. We have two Rolands that would...

My best resultes have been with the R-113 bit. Also before I route I put 2 layers of pre-mask on the sheet, and put that side down on the table. And from my experiance use a "soft acrylic" I forget if thats extruded or cast. Most important use new mats if its going to be smal letters.

I call BS on your comment that a Zund can NOT cut a 1/4" hole! I just did in 3/16 foam core and it looks beutiful!