Recent content by kussione

Hi together, the problem is solved. I changed the mainboard with a used one, and it works. Did anyone repair a roland mainboard? Because the unsed Roland board isn´t mine. :-( Another question, I have a old board on stock, but I can´t get any message on the display and the RJ45 board gets no...

I together, I had a nice phone conference with a roland technician. He told my, I changed all, what he would change. Is it possible in your opinion that my supplier sent me a defect tool carriage board? I order a new one, because the pinch roll sensor has to work while moving the carriage. I...

Hi, I have some, but not all. :-( What to you want to know especially? Kussi from Germany

Hi Robert, this is a cable on my model. A friend of mine dolt my, it could be the scan motor. I´ll change it today and will see what happens. :-) Thanks in advance Kussione

Thanks, is it possible the printer has lose the right position? I would like to format the firmware with an old one. Next week I know more. Thanks Kussi

Hi, I checkt this issue with up and down the tool but the printer isn´t setup. Well, it doesn´t work :-( The crop mark sensor is working, that means, the cable must be right. I measured al the lines in the cable and there wasn´t any electrical short. Bye the way, I did the sensor check also on...

Thank Frank, (Are we able to write in German?) I work since years with Roland and I had never such a problem. I´m shure the flad bed cable is in the right way. :-) Because I puted in in the wrong way first :-) While the sensor check I can recognize the Crop mark sensor working if I move the...

No, I´m changed the cables to the junktion board. Nothing helps. I´m goint to change the mainboard. Fortunately I have another Roland to change spare parts. Any other ideas?

Is there are a possibility to be every time setup, without measurement?

checked, all OK May be an other electrical short? Should I change the mother board? The sorvo board is changed too

I´m going to check the connection between the board and the sensor. I have no idea NIGHTMARE

Yes, it is. :-) I can recognize the sensor working while using the sensor check. Only the pinchroll sensor shows on every time. That mean a star ist every time on. If I disconnect the pinch roll sensor from the little board, it shows a star as well. Any ideas?

Bye the way, the pinch roll is in the right position :-) I have no idea, what a nightmare. HELP HELP HELP

Hi, I got a problem with my Roland. The pinch roll error is occured. I changed the sensor, the flad cable and the little board on top the cutter. Nothing helps. What a nightmare I did a sensor check and recognized, the sensor (the new one) doesn´t work. Any ideas? Is there an other...

Hi, the conversion from a roll fed to a fled bed did the company TECHNOPLOT in Germany. I did the conversion to an UV-curable printer . The UV-lamb comes from PHOSEON. At the moment I use only one lamp at the right side of the carriage but I suppose to need another lamp on the left sidetoo in...