• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by mindlesswonders

  1. roland sp540v contour cutting problem.... so frustrated HELP PLEASE!!!

    yes ill try that too

  2. roland sp540v contour cutting problem.... so frustrated HELP PLEASE!!!

    yes it does move when put pressure, but it wont do it by itself

  3. roland sp540v contour cutting problem.... so frustrated HELP PLEASE!!!

    Ok, Ill take a look at that, I didn't smell anything but what your saying sounds right. how much is that part to replace?

  4. roland sp540v contour cutting problem.... so frustrated HELP PLEASE!!!

    Thank you for the info yes that's exactly what is going on. Its just not pushing down, How or what should I do?

  5. roland sp540v contour cutting problem.... so frustrated HELP PLEASE!!!

    I have an sp540v and its a great printer, but yesterday I was contour cutting some decals and everything was going great until.., I pulled the media off the printer to weed it.... it didn't cut.... not even scratch..... I did a test cut and again the carriage was looking like it was cutting...

  6. United States, California - Hemet

    Signs 101 Network RegistryIn what country are you located? us In what state or province are you located? california In what city or town are you located? hemet What large city is nearest you? riverside Check all items that apply to your listingInstallations (Basic, no permits)...

  7. mimaki jv3 alignment

    I just got a JV3 and the alignment is off when it prints..... any point on a letter you can slightly see it pushed to the right and it has two pionts... any help on how to fix thi is greatly appeciated.
See more
Top