-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Neil's latest activity
-
Neil replied to the thread Mimaki cjv30-160 won’t pass ink type selection.You have to let it go right through the filling mode. You can disconnect the pump if you don't want it to suck ink through. There is a... -
Neil replied to the thread Installing 9.1 in windows 11.Thanks for posting that. For some reason I don't get emails from them. I just updated my SL11 to 11.2
-
Neil replied to the thread Installing 9.1 in windows 11.Hi Gray, hope you're going well. You should be able to get it to work okay. The main issue may be you need to install the latest dongle...
-
Neil replied to the thread Mimaki JV33 Magenta Nozzles Blocked.The fact that your other 3 colors came back means your cap etc is probably working okay. Sometimes though, it can be only partially...
-
Haven't messed with the nozzle replacement on ours yet, but seem to recall something about it not showing in test prints, or maybe... -
Neil replied to the thread Y Motor/servo motors and maintinance.Warning if you try that - if you adjust it too low it will cause Y overcurrent error every time it tries to move. Then you can't restart...
-
Neil replied to the thread Y Motor/servo motors and maintinance.I found on my JV33 that the belt going around the cogs was responsible for a lot of the whining noise. I cleaned the belt - got a lot of...
-
Neil replied to the thread Mimaki CJV150 Head Issue.And make sure your wiper is centered properly
-
Might be worth swapping out the capping station and making sure to perform the adjustment.
-
Neil replied to the thread Signlab 11 disappointing.They had it 50% off running for at least a few months last year till about September. Ask them if they'll still honour it for you.
-
Neil replied to the thread Cjv30 repair.Yes mate. Right here in sunny Adelaide. Happy Australia day
-
Neil replied to the thread Cjv30 repair.G'day Dan. How did you get on with the refurb printhead? Now you've fried the slider and taken out the mainboard?? Do you have the...
-
