Recent content by pete2803

Hi, thanks again for the valuble information, i have checked the leads and connections and found CN2 connection on the main board has a defective FFC lock (broken) so the FFC lead was loose have made it good and checked all the test points on the main for resistance all check out ok as per the...

Hi, thanks for the information i've just tried it and no luck, the new head is from Digiprint supplies the ID format appears the same, i initially get an error message error 202 device construction then the result of diagnosis is :- HEAD- MEM:1 Image-MEM:128MB i can go back to the result of...

Hi, did you manage to sort this problem and go back to an earlier version than 3.0?i have a similar problem and need an older firmware version below 3.0 looking for 2.2 if i can find it, thanks.

Hi all, i have a cjv30 with a non OEM head and 3.1 firmware from what i'm reading i need an older version below 3 have read 2.2 works with non OEM heads, does anyone hold on file an older version or versions than 3.1 who is willing to send me a copy or copies to try? Thanks for reading hope...

Hi, do you still have firmware below 3.0 for Mimaki cjv 30 ? looking for 2.2 if possible but anything would help looks like i have a non OEM head and version 3.1, thank you

Does anyone know if the service mode is accessible from the control panel on the LEF? thanks.

Hi did you sort this problem out did you get access to the service mode? i'd like to know how? Thanks Regards

here you go this is correct way

Does anyone know the IP address of the UJV 160 I want to connect via the network port see if I can obtain any information out of it to diagnose a problem. Thanks

instructions Send me your email address and I'll send the instructions over.

Jim, I did it myself took about 10 minutes it's not difficult with easy to follow instructions, a tech will charge you big bucks $$$$, if you make a note of original settings before you change them you can always put it back as was

Hi, your 300V will run on Windows 7 using versaworks you don't need a dongle, just install versaworks open it and add your printer, I converted my SP300 to a V so I could run it off 7 using versaworks it's works perfectly.

Try this link http://download.rolanddg.jp/en/color.html#sp300vs I don't use a dongle and I downloaded VW off the net I thought this was it, I didn't have to install a driver, let me know how you get on

You can download it free from Roland DG website

Hi Chris have you turned you're sp into a V ok?