Recent content by rivaldawg

Hi - actually, I removed the fuse and tested it with ohm meter and it showed, "good". I went ahead and ordered another one and replaced the old. I'm still in the same condition - nothing comes out of print head even though I've cleaned it and the lines are clear and ink flows in waste tank...

Did you ever find resolution to this? I'm experiencing same thing. thank you

Hi Masseria - Perfect timing! Yes indeed it helped. Another gentleman on this board has been assisting me and telling me I need to re-seat the head again so I did but i still couldn't get ink flow. Your detailed description of how the head seats with bracket and little screw made all the...

I'm trying to remove my dampers but unfortunately, i can't seem to figure out how to remove the black cover directly above the dampers. There's four built-in clips on the front of the cover. There's a video online that I followed but the part where this little cover is removed, is not shown...

ok - i'd like to try that but removing the head would be completely greek to me. Is there instructions somewhere for this? thank you!

ok - i'd like to try that but removing the head would be completely greek to me. Is there instructions somewhere for this? thank you!

Not Sure Probably, but i'm mechanically challenged. That's why I was hoping for a pic or vid. I don't trust myself in messing with this.

I have a Mutoh Drafstation RJ900 printer setup for sublimation printing. I let it sit for a while and now the head is clogged. This happened once before and i successfully unclogged it with a simple green and water formula. This time, i have successfully cleared the yellow by using the same...