• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by sacristo

  1. JV33 -DX5 printhead differences

    Hi were you able to sort out the head as I have a similar problem?
  2.

    HP LX850 PID SENSOR

    Please I would be grateful if you could advise me on the sensor type for the PID controllers for hp scitex lx850. Many thanks

  3. Mimaki jv33 No Vaccum getting no ink

    Please I have similar issue. Could you please help me? Thanks

  4. HP LX850 ERROR CODE 14.4:12

    Please could anyone help?

  5. HP LX850 ERROR CODE 14.4:12

    Thanks very much. Please how do I resolve this

  6. HP LX850 ERROR CODE 14.4:12

    Please could you help with error code 14.4:12? Regards

  7. HP LX850 ERROR CODE 14.4:12

    Please could you help with this error code? Thanks

  8. HP LX850 Error code 23.2.12

    Please I received the error code 23.2.12 after I tried to replace printhead. kind help
  9.

    HP SCITEX LX850

    Thanks . All sorted out. A cable was actually disconnected. Reconnected and now all good.
  10.

    HP SCITEX LX850

    Thanks.Yes the printed is lowered. I have removed the PPS motor and it was easy to rotate the gear but when I reinsert the motor it becomes locked
  11.

    HP SCITEX LX850

    Please the IPS says “the carriage beam is not at he correct height to perform the substrate check.Press OK to continue”
  12.

    HP SCITEX LX850

    Many thanks. Please I realised that the white disc on the front left Gear is lower than the one on the front right Gear
  13.

    HP SCITEX LX850

    Thank you.Please how do I run a test on only that motor?
  14.

    HP SCITEX LX850

    Please I did CHECK PPS MOTORS THEN IT SAID ERROR: 48.4.5:11 FAIL starting Front Left motor
  15.

    HP SCITEX LX850

    Thanks once again. I was able to locate it but I realised that when I lowered the homing switch on the front left with a screw driver and did the carriage beam recovery the code went away but it didn’t give me the option to either raise or lower the carriage beam. I have the service manual but I...
See more
Top