Recent content by SARBatavia

Thanks for your advise!

Yes, all are off the same amount. I have tried the limit initialization procedure and get to the point of "setting up cutter down position" and then I get "unrecoverable limit sensor" error. Kind of lost as to what to do next.

The printer heads were clogged after sitting idle after a few weeks so I decided to do cleaning and maintenance. I removed the ribbon cables, numbering them and then the dampners. Next the head assembly was removed. I replaced the black plastic pieces, the one with the two points the dampners go...

Spitting ink on right side of print Getting very frustrated! Attached are two photos of what my printer is doing. To review we have changed to new Roland caps, new wiper, new sponge and the drain tubes are clear and use Lyson ink. Do caps need to be aligned? Also anyone kind enough to...

We have had a multitude of problems since we switched to a third party ink. We have used 20/20 ink which I heard was made by Nazdar. Well anyway the test print from the SC-540 is good no missing sections, then we go and print an few graphics and do a test print and there are sections missing. I...

Service Manual If anyone is in a giving mood We could use a service manual for a SC-540. Having problems eith the heads. Please send to signaramabatavia@sbcglobal.net Thanks - Herb

Sorry, I mean the clips that hold the edges of the material down. Thanks

The clips on our SC-540 broke does anyone have any tips on how to install new clips and the little rods? Any and all help is appreciated.