I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Okay, I think it’s better take that extra time to be sure to not screw the new printheads.
About the maintenance station, to make sure it’s not going to contaminate new printheads with Optimizer residues, what should I carefully clean? It’s only 30%, I wouldn’t throw it away if possible. Should...
Oh okay interesting, I thought it would make too much pressure and leak somewhere because of it. Can I make it push out only few milliliters, as far as there’s no air?
And, another thing: should I do it on both the FI towers of each colour?
Well, I purged them with a syringe pulling ink from the FI towers, probably that wasn’t enough?
This morning I tried doing it from the service menu, doing the ink tubes refill, but wastes a lot of ink (pumps for two minutes). Is there a way to do it for less time?
Hi there!
I purchased an used HP Latex 330 and after some jobs that went perfectly ok, it started to make few transparent/yellowish drops on printed media. Inspecting the printheads carriage, I found a massive ink quantity inside it.
FI Towers (HP spare part code M0E29-67109 - be careful if you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.