I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
We use https://www.colorfxweb.com/ they have been great. Don't have a lot of the fancy finishes that 4over does but the quality, speed, and sales reps have been great so far.
What amount of length are you referring too? Doing less intricate cuts we can do about 20' without any issue. Key is pinch roller placement and great alignment.
Hello,
We have a client in the greater philly area that needs some damaged replaced on their Transit sides. Anyone own or know a good place that can help out?
That is exactly what I got, an M3. We have been doing more and more ad my current 1 eco solvent printer couldnt keep up so I think in busy weeks we are between 3-5 boxes a week now but we have picked up a lot of contracts recently that should see that number double next 1-2 years is my estimate.
Hi Christian,
Thanks for all the great information on this unit. We signed up for one and are just waiting to receive but I have a bit of worry. We are not a large production house, we maybe go thru 3 boxes of media in a busy week. The ability to print white and more substrates than...
Ya we laminate just about everything now that isn't corex or throw away event stuff. We were using arlon 3170 as that was a nice sweet spot but since that 86'd we have done the cast/cal combinations to save a few bucks.
Trying to find anyone with industry experience has been difficult, everyone wants to be a graphic designer it seems. I am finding its best to find the right personality and then send em to all the trainings than beat our head against a wall for someone with experience. Mind sharing what an...
Hello,
We were seamlessly using the WinPlot for Adobe CC extention to add OPOS lines and exporting directly from CC to cut then all of a sudden Adobe cannot find the extension. We have removed and reinstalled all summa software with no luck. Anyone run into this issue and have a fix?
The edge of the slats for the reflective to sit on is very small and on some units there is a foam back liner. Ours in the past using this have curled up after a few uses. I have always seen the vinyl trimmed 1/16" short top/bottom of each slat.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.