• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. question about manual contour cutting

    I have an Older cutter (Newstar OM-60) it uses the same blade/pen holder as most Mimaki's My question is this... I use FlexiSign and to do contour cutting I must do the manual alignment method. for this I have to remove the blade holder and install the pen holder... I then start moving the...

  3. Issue printing from Flexi 8.1 to HP z2100 44" on sheet media

    Tried loading a sheet as a roll... didn't work, says it's too narrow. I was loading a letter size sheet this time as for heatpress sheets it will either be letter or ledger size. I did however solve the problem. On the RIP screen, in the advanced tab, there is the driver options button. In...

  4. Issue printing from Flexi 8.1 to HP z2100 44" on sheet media

    I did think of trying that, but ran out of time. I will try loading a sheet as a roll when I get a chance.

  5. Issue printing from Flexi 8.1 to HP z2100 44" on sheet media

    at first I thought that so I tested with different print sizes... so lets say I put in a 24x30 sheet. and I print off a 22x25 inch image... it cuts off an inch off of the image. Using that same paper I print a 12x 12 inch image and it still cuts off an inch. doesn't see to matter what size...

  6. Issue printing from Flexi 8.1 to HP z2100 44" on sheet media

    I Just got a "New to me" printer (hp z2100 44" that I picked up for $500) I've done a few test prints on roll media and all is good. The problem I run into is with sheet fed media. If I load a sheet and print normally trough the windows driver everything is good. But if I try rip (need...
Top