I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Thanks, I have got it hooked directly to the computer. I have also tried on (2) PC's with (2) different cables. That should eliminate that the Ethernet board is bad shouldn't it?
Please help.
I have a Mutoh 1204 printer that has been working great till the other day. It started printing only 1/2 of the job. Now I get cannot open port. I checked and verified IP address on both PC and Printer and they are the same. I sent a ping and it Timed Out 4 out of 4 times.
I...
NEEDING CONTOUR CUT HELP When I print and Contour cut using 4 points it cuts off consistently. I have Flexi 8 printing on a Mutoh VJ using a GCC panther III for die cutting. I recently used it in 4 point mode and it did great a couple of times. Now it will jog about 1/4 in to the left and...
NEEDING CONTOUR CUT HELP When I print and Contour cut using 4 points it is off consistently. I have Flexi 8 printing on a Mutoh VJ using a GCC panther III for die cutting. I recently used it in 4 point mode and it did great a couple of times. Now it will jog about 1/4 in to the left and then...
I too use that method. I like to use a file at a 45 degree angle to finish the edge and keep it from lifting off. This is the same method used for laminate countertops.
HELP! MUTOH stoped printing CMY in Flexi. Only prints in greyscale. All colors print in Signlab. Anyone have any ideas. When I send a job to print it process very fast as if its not even sending the colors to the spooler. Any and all help greatly appreciated.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.