I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I recently purchased a used 38" Jr Mutoh ( about a 2004), and evidently the previous owner tried to flush pump lines, etc. with acetone or Lacquer thinner..because some of the plastic gears that transfer power from the pump motor to the pump and the teeth of gears are "gooey" and worn off so...
splinters..
If the vinyl is too agressive it will pull off wood ( small but can be a real issue) when the stencil itself is removed. A low tack stencil vinyl mask is best or you can rub the adhesive with your hand or across your pant leg to "lower" the tackiness before application..depending on...
I am looking at getting into reverse printed on backlit adhesive vinyl to put on the inside of glass for restoring slot machines. Does anyone know what kind of high quality printer, inks and media that would be best ? The photo quality prints are much finer definition than my Mutoh 38, and I...
..and don't trim it at the edge of the rubbers..cut it about 1/2 inch long and tuck it under the rubber with a squeege or plastic tool like a slim credit card ( I save the promotional ones that come in the mail).
I had some issues with this on different media where I could not get the roll in position any better without unrolling the roll..and I "tricked" the machine by putting a strip of white butcher paper the width of the media on top and the sensors read it and it printed fine.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.