Search results

Print fixtures can make a big difference in the amount of overspray and nozzle garbage you get on the print heads. If you aren't masking your substrate (whatever you're printing on) so that it is relatively flat then the excess ink blows around in the "wind" created by the head zooming back and...

Not sure who you're asking, but my experience is nozzle drop out (especially on Cyan/Magenta head closest to the UV lamp).

I agree with you- we run two of the 6042s and no matter what maintenance routine we run the heads always seem to start banding after a few months.

The manual says white maintenance only needs to be done when you AREN'T printing it on a daily basis. If you're outputting white every day you don't need to do it until a time when you aren't using the white heads. Normal prints don't use white- you have to specify it as a special pass in the...

Are you running nice long nozzle washes and checking the print test patterns every day? Can you post one of your nozzle check patterns? We run a 6042 and have fought the same fight to keep them from having nozzle drop out.

I may be missing something obvious, but if we were to print something long utilizing a takeup roll and then rear load that on the GX-640 the origin cut mark would end up on the inside of the roll. Is there a software option to tell the cutter it needs to start backwards, or am I thinking about...

I had some initial problems with artwork that included masks, effects, etc and these steps have worked every time from that point. A flattened/rasterized version always seems to go through.

I was told by my dealer that variable data jobs could be nested, but I can't for the life of me get it to work. I've nested jobs that contain contour cuts, but not variable data. The button just gets grayed out when the jobs contain VDP. Is there another setting I can look into for utilizing my...