I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
We've done 505903sqft - 47000sqm since Feb 2021.
The warranty is for 20,000sqm not for each head but for the whole machine. So after 20,000sqm - 215,000sqft the heads aren't covered under warranty anymore.
It's looking like I'm due to replace one of the magenta heads.
Do you have the 3120021 Glide shoe for blade holder (KCM-S, KCT, C2) inserted?
It stops the blade from going into the backing paper. So you can go a bit harder on the pressure without affecting the liner.
If it's your profiles don't they have a profile that's tested on another machine for a specific media so you can do a test and rule out if it's the profile or the printer specifically?
Have they fixed those Fotoba marks yet? Just need to copy the caldera setup. Being able to have the mark information in a preset/quickset would be better too.
Check the view cells read count.
You need a black and white sample. When the black sample is under the sensors it should be close to 0. For the white, it would be up around 170.
Not sure about the summa but on our zund we only use one side of the matt. We don't cut halfway through the matt, We cut just enough to cut through the board may be 0.5mm.
We also use 3mm MDF as an underlay for routing larger pieces. Rubber matt is good for smaller pieces as it also grips the...
If ICC Profiles off gives you the black. Then its clearly an ICC profile issue. Maybe someone here can post an ICC profile they are using and you could test using that?
Our print rooms don't require hearing protection under Worksafe practices but we do offer hearing protection to staff that wish to use them.
We've found these to be the best.
https://www.coopersafety.com/ear-plugs/headband-earmuffs/howard-leight-clarityr-c3-headband-earmuffs-1011146.html
It...
Because 100% of LC is more expensive than 20% of C. You also have more colors to purge etc so more wasted ink. in the EFI you have 4 light colors as well. Do you need to swap out the inks to go from 8C to 4C thus wasting even more ink?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.