Search results

Hi guys, I have a question about barcodes. I need very often to print the same file again and again. Nog I was thinking, is it possible to make a barcode for a file, that I often have to print. So I scan the code and it prints automatically the file. Or is it possible that the pc opens the...

Hi guys, I have an issue with the nozzles in the morning. There is a little contamination with cyan and yellow, after printing a small area yellow and cyan everything is fine. But if I don't print for several hours, same issue... Time for new cappings of what are your thoughts? Thanks!

Do you have a manual how to do it?

Can you give me more info about it?

Hi, my Summa F1612 is deviating slightly on the x-axis. Does anyone know what could be causing this? Calibration? Thanks in advance for the help.

So you guys never pinch the lines to change the dampers?

Thanks for the usefull info. Is it a good a idea to install thuis clamps for the future replacement? Or is it bad for the tubes?

Hi guys, Its time to replace the dampers again, i did it a year ago. Now i have a question, about you guys doing it? I discharge the ink and then i replace the dampers, and do a ink charge. Is it possible to do replacement without discharge the ink? Thanks for your advice.

See only the timings of the valves. Nothing about how to open the valves?

So the valves have to be opened manually? Or?

Do I need to open the valves of the ink? Yes I received the manual, thanks!

You can send it to bram_deschutter@hotmail.com. Thanks Is it maybe an idea to test the lines, that I disconnect the damper and pull ink out with the syringe?

The cartridges were always installed...

Ok, I understand. Cleaning the valves also with a syringe and acetone? Can I ask you, do you have maybe the service manual for the mimaki?

can you give me more info about how to inject the aceton? Do I work from the cardridge to the dampers? Or do you suggest to do better a replacement? Do you have more info about what kind of lines I need?

Hi Damon, Thanks you for your reply! Can you give me some advice for the ink line flushing? Do i need to buy for each color a cardrigde?

Hi guys, I can buy a cheap Mimaki cjv150-160, but isnt in use for 2 years. No power at all. What do i need to check before buying? Now is the question how to repair? 1) flush the ink lines 2) replace dampers 3) replace capping 4) replace pump Who has some advice? Thanks!