• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

408

  1. Gerber Sabre 408 Error Z Encoder/Motor

    I'm a newbie to this machine and had it working for a short while. Recently, when turning on the machine I got the above error. I also have an illuminated Red LED for AMP FAULT. All the green LEDs are lit apart from SPIN #2 My background is in embedded systems (mix of electronics and software)...
    • Mikexx
    • Thread
    • 408 encoder error motor sabre
    • Replies: 14
    • Forum: Gerber

  2. Gerber 408 CNC Spoil/Waste Board Tips?

    Hey! I have a 408 Gerber with vaccuum board, as for now the original waste/spoil board is pretty much non existent, it's like 1-2mm left and many places the bare alu boards under are shown. So! It's about time to get it changed, I've read a lot of people using MDF without even routing the...

  3. Job Exceeds Table Boundary

    So it's been at least 10 years since I've had to replace the sacrificial boards on my Gerber Sabre 408. I've drilled & pocketed them and find myself stuck on the milling of the material surface. I keep getting "Job Exceeds Table Boundary X: 000.002in Y:000.000in" :frustrated: TIA
Top