• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

alignment issues

  1.

    Alignment Issues on Stairwell

    Good morning everyone. My boss is prompting me to reach out for advice concerning some issues we are having with alignment on a 35' tall stairwell mural. We are printing on IJ180cv3 with 8520 laminate on an HP700W Latex printer. Using the base 3M 40C profile with 194 degrees temp. Vinyl is...

  2. ZUND won't cut on Reference point

    Hey everyone, I have never had this issue before but I've been clearing and changing the alignment to 0 before setting any reference points, then I'll manually enter it through the Zund panel, but it still cuts off of the reference point each time, I even do a laser simulation to check its...

  3. Another Double-Sided Printing Thread

    Hi Folks, I'm printing some double-sided banners for a client on blockout banner material. I've done quite a few previously but never had much success accurately aligning the 2nd side to the 1st. In this instance the banners are quite small and the print length around 1400mm. Even so, the print...

  4. Need Help Onyx - Oce 1280xt alignment issues

    Hi again all. So, I printed a sign on the flatbed today and the alignment is off. How do I fix this? I use Onyx 21 Thx as always! Caren
Top