I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I am planning to replace the scan motor on the VG-540 at our shop and was hoping for any general tips or tricks to be aware of during the process.
Hello Everyone,
Classic longtime lurker here finally made an account to chat with all you sign nerds out there!
Thanks to everyone who has posted...
Hello all, I have a Mimaki CJV30-100 and im getting a message "y over current ave".
It will do this in the initialising stage when the cutter carriage heads back to its position on the left. sometimes it will make it past this stage but when then when I test print or try to print the same...
Have had this issue several times earlier this week. Running some moderately long wrap prints, about 45 min on fast quality. Job gets about 3/4 of the way done and then printer beeps and the print head stops halfway across the platen. Display just shows "PROCESSING." Job drops off of VersaWorks...
I replaced L-bearings, Scan encoder sensor, strip, and scan motor and it still beeps the same error. I am now suspecting one of the circuit boards primaraly the servo board but at this point I can't just keep spending money. Can someone please help.
What I do notice is that when first turning...
Hi..has anybody experienced replacing the big pulley part? we tried ordering it from the supplier but it will take them 30days to ship out. do you think its ok to fabricate this part?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.