TDFcustomSL
New Member
I have just recently been having some issues with the margins on my prints. Im using Flexi10. I have my defaults set to print 1 inch up and 1 inch over in the lower right position. However, when I print it prints 1/2 inch from the edge of the media. I have tried adjusting the margins in the rip and print as well as the defaults. does anyone know what might be causing this and how to fix it? I had the spitting set to origin which put the registration marks 3 mm off the edge of the material, very tricky to get it loaded in the cutter and have the pinch roller out far enough for ARMS to read the mark while still having It barely on the edge of the vinyl. any help or advice would be greatly appreciated!!