1304 print modes

[GAC05]

Hi all,
I am not new to printing but I am new to the VJ 1304.
I did the first real run on it yesterday.
So far so good.
Now I have a good sized order to get done and could use a little help.
I'm doing some exterior 40"x40" posters on adhesive vinyl and would like to get other users advice on what mode to print them in.
Layouts have some fairly fine detail (10 or so small logos) in them.
They will be seen from the road for the most part but some will be at the entrances so people will be walking right up on them.
Deadline is a little short but not too bad so I am looking to get a good balance of print speed & quality.
I have read through the users guide but would rather hear some real world advice from people in the trenches.

Thanks

wayne k
guam usa

 

[randya]

Graphics 2 is really hard to beat.
720x720 8 pass should be artifact free and 4pt text or better.

 

[GAC05]

Randy
thanks for the answer - which wave pattern would you suggest with graphics 2?

I have to say I have been impressed with Mutoh support so far.
I sent an email to tech support on a ink cart issue and got an answer within about 10 minutes.

wayne k
guam usa

 

[Stealth Ryder]

Graphics 2 is really hard to beat.
720x720 8 pass should be artifact free and 4pt text or better.

Agreed...

 

[randya]

I like fine and wave 2, I find it to be very forgiving, but most here use fuzz.