E016 TLB - S(03) Error

[printimage]

I have a vj1204 printer and went to print something and this E016 TLB - S(03) came up with all lights flashing what cause this?
Now even if i try to do a nozzle test it comes up also if i have to send a job to print.
What can i do or what is the cause?

Thanks

 

[chrisphilipps]

If you have older firmware than it could be a bug and updating the firmware would fix it. Otherwise E016 typically mean your mother board is failing.

 

[printimage]

If you have older firmware than it could be a bug and updating the firmware would fix it. Otherwise E016 typically mean your mother board is failing.

How do you update the firmware? I have verson 1.2.
I have some bulk ink for it also would I be able to still use it or would have to buy chips for the new firmware?

 

[Solventinkjet]

E016 TLB - S(03) is specifically a main board error that has to do with data storage on the memory. With the machine powered off and unplugged, after waiting about 15 minutes for the machine to discharge, pull the memory card out of the main board and use duster to clean out the terminal and the memory itself. Install the card back onto the board and see if that helps. If not, it's a new main board for you.

 

[printimage]

E016 TLB - S(03) is specifically a main board error that has to do with data storage on the memory. With the machine powered off and unplugged, after waiting about 15 minutes for the machine to discharge, pull the memory card out of the main board and use duster to clean out the terminal and the memory itself. Install the card back onto the board and see if that helps. If not, it's a new main board for you.

Not to sound like a new b as i am but where is the main board located?

 

[printimage]

Not to sound like a new b as i am but where is the main board located?

Hi I found the main board and i remove the memory and reseat it and screw back up and it didn't change. Do you suggest updating firmware to see if that would work before i get a main board?

 

[printimage]

Hi I found the main board and i remove the memory and reseat it and screw back up and it didn't change. Do you suggest updating firmware to see if that would work before i get a main board?

I updated the firmware to 2.2 from the mutoh site and it install and now when i turn on the printer it have a next error E016 TLB -L/T (02)
so am i wrong to say my main board has come to an end?
Any other ideas apart from main board?